Anthem Statement D1 Instruções de Operação descarregar pdf (Página 42)

6. REMOTE CONTROL OPERATION

Dr. Jekyll and Mr. Hyde, as you may know, were two

very different personalities, even though they were

the same person. Well, the Statement D1 Remote

Control is the host to NINE different personalities!

(All of them ‘good’, of course.)

The Statement D1 Universal Learning Remote

Control has all of the same functions as the front

panel buttons and is operated in a similar way, but

there are some differences. Please take the time to

read this section to fully understand all the

functions of the Statement D1 remote Control.

The keys labeled in this illustration show those that

have a different method of operation from their

front panel counterparts. Those shown in bold

italics indicate keys that are unique to the Remote

Control and not found on the Front Panel. For a

detailed layout diagram see section 3.3.

To install the batteries, remove the cover that is on

the bottom of the remote, and be sure that they’re

installed with the correct polarity. Down the road, if

the keys don’t light up when they’re pressed, and

the red LED blinks twice, it’s an indication that the

batteries need replacement – use only ‘AA’ alkaline.

Before we get started, we have to give the remote

a little attitude adjustment – set the ‘personality’ to

MAIN by pressing MAIN near the top of the remote.

Note

: The Path / Component keys do not

transmit any commands to the Statement D1,

or anywhere else. They only determine where

subsequent commands are sent. For example,

if ZONE2 is selected followed by VOL

, then

the volume changes in ZONE2 while MAIN and

all other components remain unaffected.

6.1 POWERING THE STATEMENT D1 ON AND OFF

Two separate keys are used to turn the Statement D1 On/Off, because

discrete power commands are required in most custom installations.

First set MAIN, ZONE2, or ZONE3 personality in SSP Path.

• Power ON: Press POWER.

• Power OFF: Press SSP OFF.

SLEEP

INPUT

FRT CTR

PIP SWAP MOVE

SSP SOURCE

COPY

AUX TAPE

DVD

SAT

VCR

DVD

SAT VCR

2-Ch

REC

MAIN

SSP PATH

VOLUME CH PRE-SET

FM/AM PRE-SETS

TUNE

SEEK

SOURCE SEEK

ENTERMUTE

SELECT

SUB

LFE

SUR

1 2

6-Ch

LAST

SSP Path/Component

(‘Personality’)

Sleep and Timers

Enable/Disable

Lip-Sync Delay

Source Seek

FM • AM Presets

RECORD Path

IR Transmitter

Power ON

Transmission Indication

Learning Mode

Statement D1 Power OFF

MAIN Source Copy

Source Selection

•FM • AM Seek / Tune

• Level / Bass / Treble /

Balance / Display /

Timers Adjustments

• Mode / DD Dynamics /

THX Options selection

• Navigation (North /

South / East / West)

FM•AM Presets

UP / DOWN

FM•AM Direct Entry

MAIN

SSP PATH

LAST

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 85 86

Comentários a estes Manuais

Sem comentários

Anthem Statement D1 Instruções de Operação Página 42

Comentários a estes Manuais

Manuais e produtos relacionados com Recetor Anthem Statement D1