Anthem Statement D1 Instruções de Operação descarregar pdf (Página 74)

Software installation procedure:

1. Find out which Software version you currently have by pressing STATUS.

2. Go to the ANTHEM web site (www.anthemAV.com) and locate the latest Statement D1 Software

version. Proceed only if your version is a lower number, indicating that it is older.

3. Click on the download icon. You will be asked where to save a file called ‘statementd1v1.zip’ – save

it to your computer’s desktop.

4. Double click on ‘statementd1v1.zip’. If you computer tells you that the file cannot be opened, you

can download a program that can open the file through one of the links on the ANTHEM web site.

5. Drag or extract ‘Statement D1 Installer.exe’ and ‘Read Me First.txt’ to desktop. ‘Read Me First.txt’

lists the latest software changes. You can now delete ‘statementd1v1.zip’.

6. Ensure that your current Statement D1 Setup configuration is saved (see section 7.4.11).

7. Turn off your Statement D1 and disconnect the power cord to prevent the possibility of a static

discharge when the serial port is connected. Tuner presets, speaker level settings, bass/treble, etc.

are automatically written to memory if the line voltage is disconnected or during a power failure.

8. Using the serial cable, connect your computer to the Statement D1 via the RS-232 port on the rear

panel. Updating does not require moving the Statement D1 or disconnecting it from your system, as

long as you can connect your computer to the RS-232 port.

9. Plug the Statement D1’s power cord back in and turn the rear panel switch on.

10. Double click on ‘Statement D1 Installer.exe’, then click on ‘Install Upgrade Now’. In a few minutes,

the installation and verification will be completed.

Restore Settings?

You do not need to Restore or Recall any settings after installing new software. The Statement D1 will retain

the settings that were in use before the update, except that the day and time will be set according to your

computer’s day and time settings – if re-adjustment is required, see section 7.4.1.

Troubleshooting:

If the Installer keeps returning a message that says ‘Statement D1 Not Found’ after several attempts, restore

Factory Defaults in the Setup Menu, try installing again, and reload User Settings once the new software is

installed. If that doesn’t work, make sure that the serial port on your computer isn't already being used by

another application, such a docking station for a personal organizer – you must go into the application that

is using it to turn off the serial port.

8. SOFTWARE UPDATING continued …

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 85 86

Sem comentários

Anthem Statement D1 Instruções de Operação Página 74